The following factory MODEL
settings are pre-installed. You can chenge setting by Servo Model Selector
setting(All category) 2:"Cody King"setting(1/8GP - Off road)
3:2016Japan national-turf(1/10EP Off-road) 4:Dirt(1/10EP
Off-road) 5:For Technical Circuit(All category)
Current servos have the
appearance of high speed and high power from the response of 2.4GHz and the
power from Li-po batteries respectively. This creates a huge demand upon the
servo. The RSx is the racing servo with the durability and operability to employ
this high-spec demand.
The middle case is machined
from one piece of aluminum that incorporates the gear pins and motor being held
properly in place. The top case rigidity has been improved with the addition of
two screws in the middle to prevent flex and keep the gears properly aligned.
The upper Hard Case (H.C) is also machined from aluminum. H.C is the distinction
of durability for categories that demand high stress.
A servo motor is a very
important part of a servo. The specification of a servo is up to the motor being
used. We have developed a new motor suitable for the new R/C standard with
numerous performance and stress tests.
#Torque:17.6Kg-cm Speed: 0.06sec/60deg(@7.4V)
#Torque:14.5Kg-cm Speed: 0.07sec/60deg(@6.0V)
#Dimensions: 41x38x20cm(Standard size)
#Operating voltage:6.0 to 7.4V(Lipo,Life,Ni-MH)
#The hard alumite aluminum gear
#The hard servo gear shaft
#The aluminum top case
#The aluminum heat shink middle case
#Gold plated connector